Advertisement
Cable Cubby F55 Edge • Installation Guide (Continued)
Installing Modules into the Cable Cubby F55 Edge
The following illustration shows the process for installing the double-size Flex55 AC+USB 130 US Power Module into the Cable
Cubby F55 Edge enclosure. Note that half- and full-size modules can be snapped into the enclosure without removing the
1
). Retractor modules also can be installed, in any slot in the enclosure (see the Cable Cubby F55 Edge Retractor
supports (
Setup Guide, available at www.extron.com, for more information).
Extron Cable Cubby
F55 Edge Enclosure
Removing a Module Support for Double-sized Flex55 Installation
Figure 4.
2 2 2
Install the cable grommet plate for cable pass-through applications.
c
Snap included grommet plugs
into any unused holes in the
grommet plate.
Installing the Cables
Figure 5.
4
1
Plan and prepare the enclosure for
module installation.
For a double-size module installation,
use pliers to carefully twist the desired
bridge support back and forth until loose,
and remove.
NOTE: Removal of a bridge
support is irreversible.
a a a
For cable pass-through installation,
insert the cables through the bottom
of the Cable Cubby F55 Adapter Module
and through the holes of the grommet plate.
b b b
Snap the grommet plate
into the Adapter Module.
Advertisement
