Table of Contents
Advertisement
SP 5080
1.4
Proper use
The SP 5080 shredder and baling press combination is to be used exclusively for shredding
and compressing paper and cardboard. Its sturdy cutting unit is not damaged by paper
clips and staples. In machines with cutting widths of 6 x 40–53 mm, 7.5 x 40–80 mm and
10.5 x 40–76 mm you can also shred entire folders. Other types of material are excluded.
Function sequence:
The above-mentioned material is fed into the shredder. The shredded material falls through
the discharge chute of the shredder directly into the press chute. The press cycle is initiated
by the light barrier in the chute when it has fi lled up to a certain level. The press ram is
extended and pushes the material into the press channel, where it is compacted. The
shredder continues to run during the pressing cycle. Once the bale has reached a certain
length, it must be ejected into a side-gusseted bag. Then the pressing cycle can continue.
Any other use is considered improper. The manufacturer accepts no liability for damage
resulting from improper use. The operator carries sole responsibility for such use.
Proper use also includes carrying out installation, assembly, disassembly, start-up, operation
and maintenance work as prescribed by the manufacturer. The machine may only be
operated, serviced and repaired by staff who are familiar with these regulations and aware of
the dangers.
The shredder and baling press combination may only be operated by authorised, trained staff.
Do not carry out any tasks which may endanger your safety while operating the machine.
The relevant accident prevention regulations and any other generally recognised health and
safety standards must also be observed.
2.993.999.520_en
11
09/2015
Advertisement
Table of Contents
