Table of Contents
Advertisement
5.3.2
Tightening the tension on the conveyor belt
–
Turn off the shredder
–
Loosen the hex nuts (3) on the left and right sides of the snub roller.
(accessible from below)
–
Loosen the lock nuts (4) of the tensioning bolts (5).
–
Use the tensioning bolts to tension the conveyor belt evenly.
3
–
Tighten the hex nuts on the snub roller and the lock nuts on the tensioning bolts again.
5.3.3
Checking the directional stability of the conveyor belt
Switch on the shredder and let it run for approx. 10 minutes.
During this time, the conveyor belt must run in the middle of the snub roller.
If it slips to the left or right edge, you must alter the setting of the snub roller.
5.3.4
Checking the conveyor belt for wear
The surface of the conveyor belt can become worn after long periods of use.
If you can see the fabric inlay in the belt, it must be replaced.
Please notify our customer service.
09/2015
3
4
Note
Only tighten the conveyor belt until it stops slipping. The feed belt bearing may
be damaged if it is tightened too much.
2.993.999.520_en
SP 5080
5
51
Advertisement
Table of Contents
