Actual Values; Automatic Start Operating Mode - HSM SP 5080 Operating Manual

4.1.4

Actual values

You can call up the following actual values:
• Working hours
• Bales
• Bales / day
• Press strokes
4.1.5

Automatic start operating mode

Automatic start operating mode means:
• The FA 500.3 is switched on and ready for operation.
• "Automatic start" operating mode has been selected.
• In the display, the
• The pressing cycle runs automatically as long as the light barrier in the hopper is broken
by material to be pressed.
The press ram moves forward and compresses the material. After the compression time has
expired, the press ram automatically moves back to the rear limit position.
The motor switches off automatically after a set run-on time.
Once the set bale length has been reached, the "Bale ready" message appears in the display.
32
symbol appears.
Note:
If you press the menu button twice, the "Automatic Start" switches off
immediately.
The press goes into manual mode and the press ram can be moved
forwards or backwards.
The automatic start must be reset again each time it is switched on
using the main switch!
2.993.999.520_en
SP 5080
09/2015