Table of Contents
Advertisement
3.8
Assembling the shredder and baling press combination
09/2015
Danger!
Open cutting elements, blade rollers.
Can cut off fi ngers and hands.
Neither the shredder nor the combination press may be switched on before
both devices are properly connected and bolted together.
S
A
2.993.999.520_en
SP 5080
1. Dismantle the 2 cross members (S) on
the shredder and lock the braking castors
on the press.
2. Push the shredder over the press
from behind.
3. Insert the plug of the connection cable into
the socket of the shredder and lock it into
place.
4. Carefully push it forward until the
discharge chute of the shredder
touches the press loading hopper.
Watch out for the cable!
5. If the shredder cannot be completely
pushed up to the press shaft, loosen
the cover (A) and then tighten it again.
6. Screw the shredder and the baling press
together using the 4 nuts.
23
Advertisement
Table of Contents
