Shredder Control Panel; Display: Baling Press Not In Automatic Mode; Display: Baling Press Operating State - HSM SP 5080 Operating Manual

4.2

Shredder control panel

Display: Door open
or emergency stop
actuated
Display: Level 1 overload
No function
4.2.1

Display: Baling press not in automatic mode

This symbol lights up red if the press is not in the automatic mode.
4.2.2

Display: Baling press operating state

This symbol lights up
green when the baling press is in automatic mode.
yellow when the bale is ready for strapping.
red if a fault occurs in the baling press.
09/2015
1
Note
The shredder can only be operated when the press is in the automatic mode.
2.993.999.520_en
SP 5080
R button:
Cutting unit runs in reverse
Display: Baling press
operating state
Display: Oil reservoir empty
Function button "On / Off / Start"
Display: Level 2 * overload
2
No function
Z
Display: Ready for operation
35