Pole Mounting - Optex Smart Line Series Installation Instructions Manual

2-7 POLE MOUNTING

< Installing one detector >
1 Using a screwdriver or similar tool, break the knockout position (x4) in the chassis as shown.
2 Fix the chassis on the pole.
If two detectors are installed,
the distance between the
upper and lower detector
should be at least 20mm.
Side wall
Distance from the side wall:
at least 1m
M4×30 screw
(with rubber washer)
3
Perform the wall mounting procedure of 4 to 5 on page 7.
Make function settings and optical alignment before mounting the cover.
< Installing two detectors in opposing directions >
1
Using a screwdriver or similar tool, break the knockout position
(x4) in the chassis as shown.
Inside pair of
knockouts
marked "②"
Note>>
• Choose a different pair of knockouts.
Pairs of the knockout positions are marked "②" and "③".
3
Perform the wall mounting procedure of 4 to 5 on page 7.
Make function settings and optical alignment before mounting the cover.
If you accidentally open an unnecessary knockout, be sure to fill the knockout with rain tight composite
like silicone rubber. Not doing so may result in waterproof failure and malfunction of the product.
Outside pair of
knockouts
marked "③"
Note>>
• When mounting the single set of detectors to the pole, use
a pair of the inside knockouts.
The knockout positions are marked "②" as shown.
• Break the knockout from the direction shown (inside the
chassis). Breaking from the opposite direction (outside of the
chassis), makes a risk of generating burrs scratch the wire.
Caution
Note>>
• Before fixing the chassis on the pole, temporarily fix one
point at the center of the pole mounting bracket to the
back of the chassis.
3×6 self tapping
• Install the unit vertically at a height where an object can be
detected without fail. In case to be stacked, be careful to
cover the detection area totally.
2
Fix the chassis on the pole.
3×6 self tapping
Note>>
• Before fixing the chassis on the pole, temporarily fix one point
at the center of the pole mounting bracket to the back of the
chassis. Refer to procedure 2 of "Installing one detector".
-8-
Knockout position
M4×30 screw
(with rubber washer)