Pole Mounting - Optex AX-100TFR Installation Instructions Manual

3-2 POLE MOUNTING

-Single set
Remove the chassis from the back box.
1
2 Using a screwdriver or similar tool, break the knockout
portion as shown.
Install three pole mounting brackets on the chassis.
3
M3×8 screw Pole mounting bracket
(supplied) (supplied)
Fix the chassis on the pole.
4
After mounting the chassis, wiggle the tamper bushing
with your thumb and forefinger to ensure the tamper
works properly.
Knockout two locations pairing
in a horizontal line.
Install the bracket in the
knocked-out locations
in step 2 .
U-bracket
(supplied)
M4×30 screw
(supplied)
Caution
Take steps 3 through 6 refer to sec. "3-1" to install the
5
wireless transmitters and batteries in the back box, and then
install the back box on the chassis.
Tighten the
back box lock screw.
-Two detectors in opposing directions
Remove the chassis from the back box.
1
Using a screwdriver or similar tool, break the knockout
2
portion as shown.
Install three pole mounting brackets on the chassis.
3
M3×8 screw Pole mounting bracket
(supplied)
(supplied)
-4-
Detector 1
Choose a different
pair of knockouts.
Detector 1
Install the bracket in the
knocked-out locations
in step 2 .
M3×8 screw Pole mounting bracket
(supplied)
(supplied)
Detector 2
Detector 2