Pole Mounting - Optex AX-100 TFRi Installation Instructions Manual

3-2 POLE MOUNTING

-Single set
Remove the chassis from the back box.
1
Using a screwdriver or similar tool, break the knockout
2
portion as shown.
3
Install three pole mounting brackets on the chassis.
M3×8 screw Pole mounting bracket
(supplied) (supplied)
4
Fix the chassis on the pole.
Caution
After mounting the chassis, wiggle the tamper bushing
with your thumb and forefinger to ensure the tamper
works properly.
Knockout two locations pairing
in a horizontal line.
Install the bracket in the
knocked-out locations
in step 2 .
U-bracket
(supplied)
M4×30 screw
(supplied)
5 Take steps 3 through 4 refer to sec. "3-1" to install the
wireless transmitters and batteries in the back box, and then
install the back box on the chassis.
Tighten the
back box lock screw.
-Two detectors in opposing directions
Remove the chassis from the back box.
1
Using a screwdriver or similar tool, break the knockout
2
portion as shown.
Install three pole mounting brackets on the chassis.
3
M3×8 screw Pole mounting bracket
(supplied) (supplied)
-4-
Detector 1 Detector 2
Choose a different
pair of knockouts.
Detector 1 Detector 2
Install the bracket in the
knocked-out locations
in step 2 .
M3×8 screw Pole mounting bracket
(supplied) (supplied)