Dimensions Of Flue Gas Outlet Pipe - REMEHA Gas 210 Ace 80 Installation And User Manual

Fig.8 Sample string
EN 14471 - T120 P1 W 1 O50 LI E U0
2 3
1
EN 1856-1 - T120 P1 W VxL40045 G(xx)
Tab.11 Overview of material properties
Version Flue gas outlet
Material
Single-wall, rigid Plastic
Stainless steel
Thick-walled,
aluminium
(1) according to EN 14471
(2) according to EN 1856
(3) according to EN 13501-1
4.5.3

Dimensions of flue gas outlet pipe

Fig.9 Dimensions of open connection
ød
1
7837114 - v.01 - 10012023
4 5
AD-3001120-01
Material properties
With UKCA marking
(1)
Temperature class T120 or
(2)
higher
Condensate class W (wet)
(2)
Pressure class P1 or H1
Fire resistance class E or bet­
ter
(3)
Tab.12
100 mm
110 mm
150 mm
200 mm
AD-3001094-01
1 EN 14471 or EN 1856–1: The material is UKCA approved
according to this standard. For plastic this is EN 14471, For
aluminium and stainless steel this is EN 1856-1.
2 T120: The material has temperature class T120. A higher number
is also allowed, but not lower.
3 P1: The material falls into pressure class P1. H1 is also allowed.
4 W: The material is suitable for draining condensation water
(W='wet'). D is not allowed (D='dry').
5 E: The material falls into fire resistance class E. Class A to D are
also allowed, F is not allowed. Only applicable to plastic.
Warning
The coupling and connection methods may vary depending on
the manufacturer. It is not permitted to combine pipes, coupling
and connection methods from different manufacturers. This also
applies to roof terminal and common shared flue ducts.
The materials used must comply with the prevailing regulations
and standards.
Please contact us to discuss using flexible flue gas outlet
material.
Air supply
Material
Plastic
Stainless steel
Aluminium
Warning
The pipes connected to the flue gas adapter must satisfy the
following dimension requirements.
d
External dimensions of flue gas outlet pipe
1
Dimensions of pipe
d (min-max)
1
99.3 - 100.3 mm
109.3 - 110.3 mm
149 - 151 mm
199 - 201 mm
4 Before installation
Material properties
With UKCA marking
Pressure class P1 or H1
Fire resistance class E or bet­
ter
(3)
17