Table of Contents
Advertisement
6 Preparation of commissioning
6.1.2
Filling the trap
Fig.58
Filling the trap
2
1
6.1.3
Preparing the gas circuit
Fig.59
Gas inlet pressure measuring point
P1
6.2
Control panel description
6.2.1
Control panel components
Fig.60
Control panel components
3
4
5
6
6.2.2
Description of the home screen
36
Danger
The trap must always be sufficiently filled with water. This
prevents flue gases from entering the room.
1. Fill the trap via the condensate collector.
2. Put the sealing cap back on the condensate collector.
AD-3002445-01
Warning
Ensure that the boiler is disconnected from the power supply.
1. Open the main gas valve.
2. Open the boiler gas valve.
P1
3. Check the tightness of the gas circuit.
4. Vent the gas supply pipe by unscrewing measuring point P1.
The gas supply pipe is properly vented when a gas smell can be
noticed.
5. Check the gas inlet pressure at measuring point P1.
The advised inlet pressure is shown on the data plate.
Caution
The inlet pressure may never exceed the maximum pressure
mentioned in the technical data table.
AD-3002446-01
6. Tighten the measuring point again.
1 Rotary knob to select a tile, menu or setting
2 Confirm button
3 Back button
2
4 Menu button
1
5 Display
6 Status LED
AD-3000932-02
This screen is shown automatically after start-up of the appliance. The
control panel automatically enters standby mode (black screen) if the
buttons are not used for 5 minutes. Press one of the buttons on the control
panel to activate the screen again.
You can navigate from any menu to the home screen by pressing the back
button
to confirm the selection
:
Short button press: Return to the previous level or previous
menu
Long button press: Return to home screen
to go to the main menu
for several seconds.
7837114 - v.01 - 10012023
Advertisement
Table of Contents
