Commissioning; Commissioning Procedure; Gas Settings; Factory Setting - REMEHA Gas 210 Ace 80 Installation And User Manual

7

Commissioning

7.1

Commissioning procedure

7.2

Gas settings

7.2.1

Factory setting

Tab.30 Factory settings G20 (H gas)
Code Display text
DP003 Abs max fan DHW
GP007 Fan RPM Max CH
GP008 Fan RPM Min
GP009 Fan RPM Start
Tab.31 Factory gas conversion restrictor
Diameter in mm for G20 (H gas)
7.2.2

Adjusting to a different gas type

7837114 - v.01 - 10012023
Warning
Commissioning must be done by a qualified installer.
If adapting to another gas type, the gas valve unit must be
adjusted before switching on the boiler.
1. Open the main gas valve.
2. Open the appliance gas valve.
3. Switch on the power with the boiler's on/off switch.
4. Configure the settings shown on the display.
The start-up program will start and cannot be interrupted.
5. Set the components (thermostats, control) so that heat is demanded.
Important
In the event of an error during the start-up, a message with the
corresponding code is displayed. The meaning of the error codes
can be found in the error table.
The factory setting of the boiler is for operation with the natural gas group
G20 (H gas).
Description
Maximum fan speed on Domestic Hot Wa­
ter
Maximum fan speed during Central Heat­
ing mode
Minimum fan speed during Central Heating
+ Domestic Hot Water mode
Fan speed at appliance start
Warning
Only a qualified installer may carry out the following operations.
Important
If the boiler is adapted to another gas type, this must be stated on
the sticker supplied. This sticker must be affixed next to the data
plate.
Before operating with a different type of gas, carry out the following steps.
80 120 160
5100 6400 4800
5100 6400 4800
1200 1300 1000
1700 1700 1700
80 120 160
8.4 8.4 -
7 Commissioning
200
5700
5700
1200
1700
200
-
39