Settings; Introduction To Parameter Codes; Searching The Parameters, Counters And Signals - REMEHA Gas 210 Ace 80 Installation And User Manual

8 Settings

8 Settings
8.1

Introduction to parameter codes

Fig.70 Code on a HMI T-control
...... ........ ....... ......
00:12
....................
..... ... ....... .... .. ..... ....
....... .... .. ..... ....
....... ........... CP010
..... ... ....... ....
..... ... ....... ....
..... ... ....... .... .. ..... ....... .... ..... .......
........ .......
Fig.71 First letter
Fig.72 Second letter
Fig.73 Number
8.2

Searching the parameters, counters and signals

44
When you have saved the commissioning settings, the option Revert
commissioning settings becomes available in the Advanced Service Menu.
The controls platform makes use of an advanced system to categorise
parameters, measurements and counters. Knowing the logic behind these
codes, makes it easier to identify them. The code consists of two letters
and three numbers.
.........
.......
...
......
.....
CP010
AD-3001373-02
The first letter is the category the code relates to.
CP010
AD-3001375-01
Category D codes are appliance controlled only. When the domestic hot
water is controlled by an SCB, it is handled like a circuit, with C-category
codes.
The second letter is the type.
CP010
AD-3001376-01
The number is always three digits. In certain cases, the last of the three
digits relates to a zone.
CP010
AD-3001377-01
You can search and change data points (Parameters, counters, signals) of
the appliance, connected control boards and sensors.
Use the rotary knob to navigate.
Use the button to confirm your selection.
1. Press the button.
2. Select Advanced Service Menu.
3. Select Save as commissioning settings.
4. Select Confirm to save the settings.
A Appliance: Appliance
C Circuit: Zone
D Domestic hot water: Domestic hot water
E External: External options
G Gas fired: Gas-fired heat engine
P Producer: Central heating
Z Zone: Zone
P Parameter: Parameters
C Counter: Counters
M Measurement: Signals
> Installation Setup > Search datapoints
Use the rotary knob to navigate.
Use the button to confirm your selection.
1. Press the button.
2. Select Installation Setup.
3. Select Search datapoints.
7837114 - v.01 - 10012023