Changing The Comfort And Reduced Hot Water Temperature; Increasing The Domestic Hot Water Temperature Temporarily; Changing The Operating Mode; Changing The Control Panel Settings - REMEHA Gas 210 Ace 80 Installation And User Manual

11 User instructions
11.7.4

Changing the comfort and reduced hot water temperature

11.7.5

Increasing the domestic hot water temperature temporarily

11.8

Changing the operating mode

11.9

Changing the control panel settings

74
4. Select the DHW timer program Schedule 1, Schedule 2 or Schedule
3.
You can change the comfort and reduced hot water temperature for the
timer program.
> Domestic Hot Water Setpoints
Use the rotary knob to navigate.
Use the button to confirm your selection.
1. Select the tile [ ].
2. Select Domestic Hot Water Setpoints.
3. Select the setpoint you want to change:
DHW comfort setpoint: The temperature when the hot water
production is switched on.
DHW reduced setpoint: The temperature when the hot water
production is switched off.
4. Set the desired temperature.
Regardless of the operating mode selected for domestic hot water
production, it is possible to increase the domestic hot water temperature
for a short period. After this period the hot water temperature decreases to
the Reduced setpoint. This is called a hot water boost.
> Operating mode > Hot water boost
Use the rotary knob to navigate.
Use the button to confirm your selection.
Important
The domestic hot water temperature can only be adjusted in this
way if a domestic hot water sensor is installed.
1. Select the tile [ ].
2. Select Operating mode.
3. Select Hot water boost.
4. Set the duration in hours and minutes.
The temperature is increased to the DHW comfort setpoint for the
duration of the boost.
You can set the operating mode of your appliance. The modes available
may vary per appliance.
Use the rotary knob to navigate.
Use the button to confirm your selection.
1. Select the tile [ ].
2. You can choose between the following operating modes:
Off Disable the appliance, does not affect hot water production.
Heating (auto) Enable heating.
The operating mode tile will update to reflect the selected operating
mode.
You can change the control panel settings within system settings.
> System Settings
7837114 - v.01 - 10012023