External Port; Host Processor Interface (Hpi); Sport Audio Interface - Analog Devices ADSP-21161N EZ-KIT Lite Manual

Hide thumbs Also See for ADSP-21161N EZ-KIT Lite:
Table of Contents

Advertisement

which the core operates is determined by the location of the clock mode
jumper (JP21) as described
runs at 100 MHz.

External Port

The External Port (EP) of the processor connects to a 512K x 8-bit Flash
memory. The Flash memory connects to the boot memory select (
pin and the memory select 1 (
memory to be used to boot the processor as well as to store information
during normal operation.
The external memory interface also connects to 1M x 48-bit SDRAM
memory. The SDRAM memory connects to the memory select 0 (
pin. Refer to
"SDRAM Disable Jumper (JP1)" on page 3-5
tion on how to configure the width of the SDRAM. Refer to
SDRAM Memory" on page 2-3
map.
Some of the address, data, and control signals are available externally via
two off-board connectors. The EP connectors' pinout (
found in Appendix B, "Schematics".

Host Processor Interface (HPI)

The Host Port Interface (HPI) signals are brought to an unpopulated
off-board connector (
application. The pinout of the host port connector can be found in
Appendix B, "Schematics".

SPORT Audio Interface

and
SPORT0
SPORT2
stereo jack and four RCA mono jacks facilitate an audio input, while a
3.5 mm stereo jack and eight RCA mono jacks facilitate an audio output.
ADSP-21161N EZ-KIT Lite Evaluation System Manual
EZ-KIT Lite Hardware Reference
on page
3-11. By default, the processor core
) pin. The connection allows the Flash
~MS1
for a summary of the processor's memory
). This allows the HPI to interface with a user
P9
are connected to the AD1836 codec (
)
~BMS
)
~MS0
for informa-
"Using
and
) can be
P9
P10
). A 3.5 mm
U10
3-3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ADSP-21161N EZ-KIT Lite and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents