Board Reset Push Button (Sw8); Connectors; Usb Connector (P2) - Analog Devices ADSP-21161N EZ-KIT Lite Manual
Hide thumbs
Also See for ADSP-21161N EZ-KIT Lite:
Table of Contents
Advertisement
Connectors
processor. Refer to
The push button reference designators and corresponding interrupt sig-
nals are summarized in
Table 3-12. Interrupt Switches
Interrupt Signal
IRQ0
IRQ1
IRQ2
Board Reset Push Button (SW8)
The RESET push button (
reset, the USB interface is automatically reinitialized.
Pressing the RESET push button (
ning disrupts communication and causes errors in the current
debug session. VisualDSP++ must be closed and re-opened.
Connectors
This section describes the connector functionality and provides informa-
tion about mating connectors.
USB Connector (P2)
The USB connector (
3-16
"Using FLAG Pins" on page 2-5
Table
3-12.
Push Button Reference Designator
SW5
SW6
SW7
) resets all of the ICs on the board. During
SW8
Figure 3-4
) is a standard Type B USB receptacle.
P2
ADSP-21161N EZ-KIT Lite Evaluation System Manual
for more information.
) while VisualDSP++ is run-
SW8
shows the connector locations.
Advertisement
Table of Contents
Need help?
Do you have a question about the ADSP-21161N EZ-KIT Lite and is the answer not in the manual?