Installation Tasks
When Windows XP completes the driver installation for the
selected device (see step 1), a window shown in
appears on the screen.
Figure 1-11. Windows XP – Completing Driver Installation
4. Verify the installation by following the instructions in
Driver
Installation".
Verifying Driver Installation
Before launching the EZ-KIT Lite evaluation system, verify that the USB
driver software is installed properly:
1. Ensure that the USB cable connects to the evaluation board and
the PC.
2. Press and release the RESET button (
3. Verify that the red DSP RESET LED (
blinks again in 15 seconds.
1-14
ADSP-21161N EZ-KIT Lite Evaluation System Manual
Figure 1-11
"Verifying
) on the evaluation board.
SW8
) blinks once and then
LED8
Need help?
Do you have a question about the ADSP-21161N EZ-KIT Lite and is the answer not in the manual?