Renault Duster 2007 Manual page 1053

UCH
Vdiag No.: 09
ET084
STATUS DEFINITION
NOTES
Check the connection and condition of the lighting stalk connector, component code 209 and the UCH connector,
component code 645.
If the connectors are faulty and if there is a repair procedure (see Technical Note 6015A (Renault) or Technical
Note 9804A (Dacia), Electrical wiring repair, Wiring: Precautions for repair), repair the connector, otherwise
replace the wiring.
Check for earth on connection MAM of component 209.
If the connection is faulty and if there is a repair procedure (see Technical Note 6015A (Renault) or Technical
Note 9804A (Dacia), Electrical wiring repair, Wiring: Precautions for repair), repair the wiring, otherwise
replace it.
Check the operation of the lighting stalk, component code 209 in the right-hand indicator position:
Check the continuity between connections 64S and MAM.
AFTER REPAIR
UCH_V09_ET084
MR-453-X79-80D000$080.mif
V1
LIGHTING
Fault finding – Interpretation of statuses
RIGHT-HAND INDICATOR REQUEST
PRESENT when the right-hand indicator is switched on.
ABSENT if there is no request for the right-hand indicator.
There must be no present or stored faults.
Switch on the ignition.
Activate the left-hand indicator lights control using the lighting stalk.
The status should be PRESENT.
Special note:
Use the Wiring Diagrams Technical Note for DUSTER.
Carry out another fault finding check on the system.
Deal with any other faults.
Clear the stored faults.
80D-14
80D