Fault Finding - Fault Finding Chart - Renault Duster 2007 Manual

UCH
Vdiag No.: 09
ALP 2
NOTES
Check the condition of the bulbs. Replace the bulbs if they are defective (see MR 451 Mechanical, 81A, Rear
lighting, Rear light bulb: Removal - Refitting).
Check the presence and condition of fuses F18 (10 A) and F19 (10 A) on component 1016.
Replace the fuse if the check is not correct.
Check the condition and connection of the connectors of the left-hand headlight, component code 227, the rear
left-hand light, component code 173, the right-hand headlight, component code 226, the rear right-hand light,
component code 172, the right-hand number plate light, component code 166, the left-hand number plate light,
component code 167, and the lighting stalk, component code 209.
If the connector is faulty and there is a repair procedure (see Technical Note 6015A (Renault) or Technical Note
9804A (Dacia), Electrical wiring repair, Wiring: Precautions for repair), repair the connector, otherwise replace
the wiring.
Check for +12 V (when side lights are requested) on the following connections:
• LPD of components 226 and 172,
• LPG of components 227 and 173 .
Check for earth on the following connections:
• MB of component 227,
• MG of component 173,
• MA of component 226,
• MF of component 172.
If the connections are faulty and if there is a repair procedure (see Technical Note 6015A (Renault) or Technical
Note 9804A (Dacia), Electrical wiring repair, Wiring: Precautions for repair), repair the wiring, otherwise
replace it.
AFTER REPAIR
UCH_V09_ALP2
MR-453-X79-80D000$120.mif
V1
LIGHTING
Fault finding – Fault Finding Chart
Only consult this customer complaint after a full check with the diagnostic tool.
There must be no present or stored faults.
Check the conformity of status ET324 Side lights request.
If not correct, refer to the interpretation of this status.
Special note:
Use the Wiring Diagrams Technical Note for DUSTER.
Check the system operation.
No side lights
80D-29
80D