Technosoft IDM240-5EI Technical Reference page 57

Remarks:
1. When using 24 V Pulse & Direction connection, leave Pins 12 – IN#37/D5V and 13 –
IN#38/P5V – open.
2. When IN#38/P5V is used as PULSE input in Pulse & Direction motion mode, on each
falling edge the reference (or feedback) is incremented / decremented.
3. When IN#37/D5V is used as DIRECTION input in Pulse & Direction motion mode, the
reference (or feedback) is incremented if this pin is pulled low.
Remarks:
1. When using 5 V Pulse & Direction connection, leave Pins 12 – IN#37/D5V and 13 –
IN#38/P5V –- open.
2. When IN#38/P5V is used as PULSE input in Pulse & Direction motion mode, on each
rising edge the reference (or feedback) is incremented / decremented.
3. When IN#37/D5V is used as DIRECTION input in Pulse & Direction motion mode, the
reference (or feedback) is incremented if this pin is pulled low.
© Technosoft 2011
Figure 3.26. J9 – 5V Pulse & Direction connection
46
IDMx40
IDMx40 Technical Reference