Dip-Switch Settings; Connectors Type And Mating Connectors - Technosoft IDM240-5EI Technical Reference

3.2.8. Connectors Type and Mating Connectors

Connector
J2 Motor & supply
J4 Serial
J10 & J11 CAN
J13 Feedback
J9 Analog & 24 V digital I/O
1
. The mating connector accepts wires of 0.14 ... 1.5 mm

3.3. DIP-Switch Settings

Figure 3.32. SW1 – DIP Switch for CAN
executions
•
Position 1: FU / Norm
ON:
OFF:
•
Position 2: 485/232 (CAN executions)
ON: IDMx40 drive communicates in RS-485 mode
OFF: IDMx40 drive communicates in RS-232 mode
•
Positions 3 ... 7: ID-Bitx.
Axis ID switches The drive axis/address number is set according with Table 3.1
•
Position 8: Auto / Ext (CAN executions)
ON: Sets the drive in AUTORUN mode (only with TMLCAN protocol). After power-on,
the drive automatically executes a TML program from its internal E
OFF: Sets the drive in External (slave) mode. After power-on, the drive waits for
commands from an external device. With CANopen protocol, the drive is always in
external mode independently of the switch position
Remark: All switches are sampled at power-up, and the drive is configured accordingly
© Technosoft 2011
Function
Phoenix Contact MC 1.5/8-STF-3.5
generic 9-pin Sub-D male
generic RJ11-4/4 phone plug
generic 15-pin High Density Sub-D male
generic 26-pin High Density Sub-D male
Enable Firmware Update
Normal operation
Mating connector
2
(AWG28 ... AWG16)
Figure 3.33. SW1 – DIP Switch for CANopen
executions
53
1
2
ROM.
IDMx40 Technical Reference