Table of Contents
Advertisement
Component Names and Functions
(6)(7)Power and
Ground terminal
(1)POWER LED
(2)RUN LED
(3)ERROR LED
Connector name
(1)
POWER LED
(2)
RUN LED
(3)
ERROR LED
(4)
I/O connector (control
lines, data lines)
(5)
Camera connector
(6)
Power and Ground ter-
minal
(7)
Power and Ground ter-
minal
(8)
Monitor connector (ana-
log RGB)
(9)
RS-232C/RS-422 con-
nector
(10)
USB connector
(11)
Ethernet connector
(12)
Touch pen (holder)
Vision System FH/FZ5 series Hardware Setup Manual (Z366)
Camera 2ch type
FZ5-120
FZ5-110
FZ5-80
FZ5-60
Left-side view
Front view
(10)USB connector (12)Touch pen (holder)
Lit while power is ON.
Lit while the layout turned on output setting is displayed.
Lit when an error has occurred.
Connect the controller to external devices such as a sync sensor.
Connect cameras.
Connect a DC power supply.
Wire the power supply unit independently of other devices.
After wiring, replace the terminal cover.
Connect the ground wire. Make sure that the controller is grounded with a
separate ground wire.
For FZ5-600/FZ5-1100 series, cannot connect the monitor.
For use this connector, contact OMRON representative.
FZ5-800 Series/FZ5-1200 Series: Connect monitor.
Connect an external device such as a personal computer or PLC.
Connect a USB device. Do not plug or unplug it during measurement.
Measurement time might be affected otherwise. However, when connecting
two or more USB memories, do not connect them to adjacent ports. Doing so
may cause the USB memories to come into contact, resulting in malfunction
or damage.
Connect Ethernet device.
A touch pen is stored.
Camera 4ch type
FZ5-120 -10
FZ5-110 -10
FZ5-80 -10
FZ5-60 -10
Right-side view
(9)RS-232C/RS-422 connector
(4)I/O connector
(8)Monitor connector
(11)Ethernet connector
(5)Camera connector
(10)USB connector
Description
3 Configuration
(control lines, data lines)
(analog RGB)
3 - 21
3
Advertisement
Table of Contents
