Omron sysmac FH Series Hardware Setup Manual page 203

Cable. I/O connector and Terminal Block
Use the following parallel I/O cable.
Item
Parallel I/O
Cable
Parallel I/O
Cable for Con-
nector-terminal
Conversion Unit
Connector-Termi-
nal Block Con-
version Units,
General-purpose
devices
 XW2Z-S013-
Unfused part
1
2
34
33
*1. Cable is available in 2 m/5 m.
Vision System FH/FZ5 series Hardware Setup Manual (Z366)
Model Description
XW2Z-S013- FH series only
Cable length: 2 m, 5 m
Minimum bending
radius: 10 mm
XW2Z-EE FH series only
Cable length: 0.5 m, 1
m, 1.5 m, 2 m, 3 m 5 m
Minimum bending
radius: 83.2 mm
XW2R-34G-T
Fused part
(70) (30)
Cable mark
• 2 Cables are required for all I/O signals.
• This cable is the type of one side flat cable
and another side connector.
• Connect the parallel I/O cable with more than
the minimum bending radius.
• Insert the cables length into  in the model
number as follows. 2 = 2 m, 5 = 5 m
• 2 Cables are required for all I/O signals.
• Connect the parallel I/O cable with more than
the minimum bending radius.
• Insert the cables length into  in the model
number as follows.
050 = 0.5 m, 100 = 1 m, 150 = 1.5 m, 200 =
2 m, 300 = 3 m, 500 = 5 m
• Connector-Terminal Block Conversion Units
can be connected
(Recommended Connector-Terminal Block
Conversion Unit: OMRON XW2R-34GD-T)
• Insert the wiring into  in the model number
as follows.
Phillips screw = J, Slotted screw (rise up) =
E, Push-in spring = P
Refer to the XW2R Series catalog (Cat. No.
G077) for details.
(70)
L *1
6 I/O Interface
Remark
(15)
6 - 5
6