Table of Contents
Advertisement
3-6
Touch Panel Monitor and Cable
Touch Panel Monitor of FH-MT12 is connectable FH-1000, FH-3000, and FH-L Sensor Controller
whose software is Ver. 5.32 or later.
For connection of Touch Panel Monitor and FH Sensor Controller, the monitor cable for video and touch
panel cable are necessary.
Precautions for Safe Use
About connection of FH-1000, FH-3000, FH-L series Sensor Controller and FH-MT12.
Do not ground the plus (+) terminal of the 24VDC power source when the Sensor Controller is
connected to the FH-MT12 with a USB cable.
Doing so may cause a short circuit of the internal circuit, resulting in a malfunction.
Specification
Touch Panel Monitor
Major Function Display area
External inter-
face
Ratings
Operating
environment
Operation
Structure
Vision System FH/FZ5 series Hardware Setup Manual (Z366)
Model
Resolution
Number of color
Brightness
Contrast Ratio
Viewing angle
Backlight Unit
Backlight lifetime
Touch panel
Video input
Touch panel signal
Power supply voltage
Current consumption
Insulation resistance
Ambient temperature range Operating: 0 to 50°C,
Ambient humidity range
Ambient environment
Vibration resistance
Degree of protection
Mounting
Weight
Material
FH-MT12
12.1 inch
1024 (V) × 768 (H)
16,700,000 colors (8 bit/color)
2
500 cd/m
(Typ)
600:1 (Typ)
Left and right: each 80°, upward: 80°, downward: 60°
LED, edge-light
About 100,000 hour
4wire resistive touch screen
analog RGB
USB
RS-232C
24 VDC±10%
0.5 A
Between DC power supply and Touch Panel Monitor FG: 20
MΩ or higher (rated voltage 250 V)
Storage: -20 to +65°C (with no icing or condensation)
Operating and Storage: 20 to 85%RH
(with no icing or condensation)
No corrosive gas
10 to 150 Hz, one-side amplitude 0.1 mm
2
(Max. acceleration 15 m/s
)
10 times for 8 minutes for each three direction
Panel mounting: IP65 on the front
Touch pen
Panel mounting, VESA mounting
Approx. 2.6 kg
Front panel: PC/PBT, Front Sheet: PET, Rear case: SUS
3 Configuration
3
3 - 71
Advertisement
Table of Contents
