Enable Mapping - NovaStar MX Series User Manual

Figure 7-3 Network settings
Choose Mode and then select a mode from the drop-down options.

Manual: Manually set a static IP address for the device.

Auto: The device automatically obtains an IP address.
If the manual mode is selected, set an IP Address, Subnet Mask and Default Gateway and select Apply. If the
automatic mode is selected, this step is not required.
If you want to reset the IP address to the default, select Reset.
Set the Protocol Switch
Set the SNMP and Art-Net protocol switch status.
Figure 7-4 Protocol switches
Note
For details, see the SNMP Protocol Instructions and Art-Net Protocol Instructions.

7.4 Enable Mapping

After the Mapping function is enabled, cabinets can display some information, such as the Ethernet port number and
receiving card number, allowing users to easily obtain the locations and connection topology of receiving cards.
On the main menu screen, choose Screen Configuration > Mapping.
Figure 7-5 Mapping
Enable the Mapping function by toggling on this switch
www.novastar.tech
MX30 LED Display Controller User Manual
.
22