Operation (Continued) - Modern Flames OR30-MULTI-INT Owner's Manual

8
9
2
14
7
Power
Plug the power cord into a dedicated 240 Volt 13 Amp (EU) or 10 Amp (AU/NZ) grounded outlet (see
IMPORTANT SAFETY INFORMATION). A dedicated circuit is preferred but not essential in all cases. A
dedicated circuit will be required if after installation, the circuit breaker trips on a regular basis when
heater is operating. Make sure the outlet is in good condition and the plug is not loose. NEVER exceed
the maximum amperage for the circuit.
Master Power Switch
Located above the Touch Control Panel is the Master Power Switch. Ensure the rocker switch is pressed
in the "On" position prior to operating the fireplace.
Note: After resetting the Master Power Switch or from a loss of power, the fireplace takes 20-30 seconds
before the fireplace is fully booted and operational.
Pairing the Remote
With the fireplace ON, press and hold the Power button on the fireplace for 5 seconds until you

hear a beep from the fireplace. "P1" will be shown on the display.
Within 5 seconds of the fireplace beeping, repeatedly press the power button on the remote until

the fireplace beeps again.
 Pairing must be completed within 5 seconds or the fireplace pairing will time out of pairing mode.
12
18
4
11
5

Operation (Continued)

Read and understand this entire owner's manual, including all safety
information, before plugging in or using this product. Failure to do so
could result in electric shock, fire, serious injury, or death.
www.modernflames.com
4
11
13
15
10
3
16
7
5
8
1
6
7
14
9
2
3
14
20