Konica Minolta BC-10 Plus Instruction Manual page 22

Points to Remember
Icon Displays (Status indicator icons/Measurement
setting icons)
1. 2. 3. 4. 5. 6.
7.
Turning ON/OFF Buzzer Sounds and the LED Lamp
Display
When shipped from the factory, the buzzer sound and READY lamp are set to ON.
However, these settings can be changed using the supplied PC application. For how to
confi gure these settings, read the information regarding turning the PC application
environment settings buzzer ON/OFF (Page 50) and regarding the display LED
(READY lamp) display (Page 51).
Pairing Number
The instrument and White Calibration Cap bear 5-digit numbers called "pairing number".
Before starting white calibration, confi rm that the instrument and White Calibration Cap
have the same pairing number.
(Cont.)
1. Battery status/USB power display
2. LED (READY lamp) OFF display
3. Buzzer mute display
4. Save the data to the instrument.
5. USB connection status
6. Clock
7. Target mask setting display
None Shows that the remaining battery power is suffi cient.
Shows that the remaining battery level is low. Replace the batteries.
The system will fail if the batteries are not replaced immediately.
1.
(The power will turn off automatically 5 seconds after the display
appears.)
Power is being supplied through the USB cable.
2. LED OFF (*Displayed when set to OFF from the PC application.)
3. Buzzer mute (*Displayed when set to OFF from the PC application.)
4. Measurement data is being saved to the instrument.
Shows that the instrument is attached to a PC.
5.
Shows that the instrument is attached to a printer.
6. 20:36 Time setting
7. Mask setting (MAV fi xed)
White Calibration Cap
Pairing number
The instrument and White Calibration Cap to be used together must
have the same pairing number.
22
BC-10 Plus