Konica Minolta BC-10 Plus Instruction Manual page 43

Points to Remember
[Measure] Tab
Measurement can be performed when the instrument settings are met and the PC application is running.
Memo The settings confi gured on the PC application will also be applied when measuring remotely from the PC application.
When performing remote measurement from the PC application, the "Meas. Cond." on the left side of the screen will be applied.
Mask
Confi gures the target mask for the
instrument. (Page 46)
Use Measure Button on Inst.
Checking the box on the right enables
measurement through the measuring
button on the instrument.
Memo The "Measure" key on the PC
application is disabled.
Display format switching button
This function allows the display format
of data displayed by the instrument to
be switched.
(Cont.)
Save Avg.
Saves the averages to the PC.
Memo This function is only
enabled when a
destination for saving
data has been set under
Save Meas. Data.
Avg. Reset
This function resets the successively
measured data used for determining
the average.
Undo
This function allows measurement to
be redone during averaging
measurements.
Save Meas. Data
Specifi es the destination for saving
data measured using the PC
application. It is also possible to
confi gure the settings so that
measured data is not saved.
Latest Meas.
Displays the most recent measurement
data and averages.
Max.
Displays the number of measurements
where the "Y" value was the highest
within the measurement data.
Min.
Displays the number of measurements
where the "Y" value was the lowest
within the measurement data.
Measure
Measures remotely from the PC
application.
43