Command Procedures; Remote Commands - Compaq AA-Q88CE-TE System Manager's Manual

where
error-identification
The following sequence returns an error message,
explained by the
% rtr
RTR> start rtr
%RTR-F-RTRALRSTA, rtr already started
RTR> help errors rtralrsta
Errors
RTRALRSTA
RTR already started
Explanation: RTR was already running when the "START RTR" command
was executed. This error message is displayed by the RTR utility.
RTR>

1.4 Command Procedures

RTR commands can also be written in a command file and then executed as a
procedure using the
% rtr execute createfacil
or:
% rtr @createfacil
or at the RTR prompt:
% rtr
RTR> execute createfacil
or:
RTR> @createfacil

1.5 Remote Commands

Most RTR commands can be issued either locally (the default) or on one or more
remote nodes. To be able to issue commands to a remote node you must have an
account on that node with the necessary access privileges. Refer to your operating
system documentation for information on how to set up the access privileges.
To specify the remote node names explicitly:
RTR> command/node=node-list
To specify remote nodes implicitly, if for example the command is to be executed
in every node of a clustered environment use a command of the following form:
RTR> command/cluster
Examples:
RTR> start rtr/node=(nodeA,nodeB,nodeC)
is the identification part of the returned error.
help errors rtralrsta
or
EXECUTE file-spec
1.3 Online Help
RTRALRSTA , that can then be
command option:
commands. For example:
@file-spec
Introduction
Introduction 1–3