Compaq AA-Q88CE-TE System Manager's Manual page 256

TRIM FACILITY
RTR MONITOR QUORUM displays a monitor picture which allows the quorum
negotiations to be observed. You can use this after using a TRIM FACILITY
command; once quorum has been re-attained, the participating nodes return to
the quorate state.
For example, in a three node facility called
only frontend roles, and node
This facility could have been created as follows:
% RTR
RTR> SET ENVIRONMENT /NODE=(FE,FETRBE,NFE)
RTR> CREATE FACILITY facnam /FRONTEND=(NFE,FE,FETRBE) -
The frontend node
% RTR
RTR> SET ENVIRONMENT /NODE=(FETRBE,NFE)
RTR> TRIM FACILITY facnam /FRONTEND=NFE
Parameters
facility_name
Specifies the name of the facility to be trimmed.
The default value for
Qualifiers
/BACKEND=backend-list
/NOBACKEND (D)
Specifies the names of the nodes where backend roles for this facility are removed.
backend-list
than one
backend-node
specifies a text file containing a
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither
nodes specified by the latest
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/FRONTEND=frontend-list
6–180 RTR Command Line Interface
FETRBE
/ROUTER=FETRBE -
/BACKEND=FETRBE
can be removed from the facility as follows:
NFE
facility_name
is a list of backend-nodes
, then
backend-node backend-list
is either the name of a node or
nor is specified then the command is executed on the
/NODE /CLUSTER
SET ENVIRONMENT
facnam , the nodes
has frontend, router and backend roles.
is RTR$DEFAULT_FACILITY
separated by commas. If there is more
must be enclosed in parentheses.
@file-spec
on each line.
backend-list
command. If no
FE and NFE have
.
, where
file-spec
SET ENVIRONMENT