Compaq AA-Q88CE-TE System Manager's Manual page 197

/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither
nodes specified by the latest
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/INACTIVITY_TIMEOUT[=secs]
/INACTIVITY_TIMEOUT=60
/INACTIVITY_TIMEOUT[=secs]
current links, and also sets the default inactivity timeout value for new links.
The default value is 60 seconds.
See SET LINK/INACTIVITY_TIMEOUT for further information.
/ISOLATE
/NOISOLATE (D)
The /ISOLATE qualifier is obsolete, and is available for compatibility reasons
only. Use
Use /NOISOLATE to take a node out of the isolated state. (See the
/AUTOISOLATE qualifier for further information).
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in
node-list
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file
/OUTPUT
Related Commands
•
SHOW NODE
•
SET LINK
Examples
RTR> SET NODE /NOISOLATE
This command tells RTR to set the executing node non-isolated.
nor is specified then the command is executed on the
/NODE /CLUSTER
SET ENVIRONMENT
specifies the link inactivity timeout value for all
instead.
/AUTOISOLATE
is omitted then the command is executed only on the node where the
or is omitted then the standard or default output is used.
file-spec
SET NODE
command. If no
SET ENVIRONMENT
node-list
file-spec
RTR Command Line Interface 6–121
. If
. If