Compaq AA-Q88CE-TE System Manager's Manual page 249

Qualifiers
/ASTLM=ast-limit
/ASTLM=(max-links + max-processes)
Specifies the AST limit for the RTR ACP.
The value for
scheduling and a minimum of two per DECNET logical link maintained by RTR.
For example, in a 20-node configuration, a router node needs an ASTLM of at
least 45 ( 5 + (20
In systems where a lot of traffic is expected, defining additional ASTLM quota
will enable lookahead I/O to be booked to channels without RTR ACP being held
up in a resource wait.
The default value of
/LINKS and /PROCESSES.
/BIOLM=io-buffered
/BIOLM=(max-links + max-processes)
Specifies the maximum number of system-buffered I/O operations that the RTR
ACP can have outstanding at any one time.
The default value of
and /PROCESSES values.
/BYTLM=buffer-limit
/BYTLM=1,000,000 (D)
Specifies the maximum amount of memory, in bytes, that the RTR ACP can use
for buffered I/O operations or temporary mailbox creation.
This should be sufficiently large to account for lookahead DECNET traffic.
The default for
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither
nodes specified by the latest
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/CPULM=time-limit
/CPULM=default-time-limit (D)
Specifies the maximum amount of CPU time (in delta time) allocated to the RTR
ACP. The unit of
ACP is deleted.
The default value is established at system generation time.
A
time-limit
must include five for RTR ACP mailbox reads and timer
ast-limit
2
2) ).
is automatically calculated, based on the value of
ast-limit
io-buffered
is 1,000,000.
buffer-limit
nor is specified then the command is executed on the
/NODE /CLUSTER
SET ENVIRONMENT
is ten milliseconds. When the time expires, the RTR
time-limit
limit of 0 indicates that CPU time is not restricted.
2
2 + 10 = default ast-limit (D)
2
2 + 10 = default io-buffered (D)
is automatically calculated, based on /LINKS
command. If no
RTR Command Line Interface 6–173
START RTR
SET ENVIRONMENT