Table of Contents
Advertisement
/CONFIGURATION
/NOCONFIGURATION (D)
Specifies that the facility configuration is to be displayed. The configuration
information indicates the role(s) of the the node where the command is executed,
and
Whether router call-out servers or backend call-out servers have been
configured,
Whether load balancing has been configured,
Whether quorum check is being handled on this node.
Whether reply consistency check for replayed messages is enabled.
/COUNTER[=counter-name]
/NOCOUNTER (D)
Specifies that the facility counters are displayed.
of the counter. If
counter-name
Counter-name
may contain wild card characters.
/FULL
/NOFULL (D)
Equivalent to specifying
/LINKS
/NOLINKS (D)
Lists all links to connected nodes in the facility (including the node where the
command is executed. The following information is shown for each link:
Whether the node on this link is active as frontend, router or backend roles.
What kind link is active, that is,
frontend to router
router to frontend
router to backend
backend to router
Whether the router and backend roles are quorate,
Whether the router role is the current router for the frontend,
Whether the backend role is acting as a load balancing coordinator.
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in
is omitted then the command is executed only on the node where the
node-list
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file
or
is omitted then the standard or default output is used.
/OUTPUT
file-spec
/STATE
/NOSTATE(D)
Specifies that the state of the facility is displayed.
On nodes having a backend or router role, the quorum status is shown. Also, the
current quorum threshold is shown (default quorum value is shown as zero), and
the minimum broadcast rate (if it has been set).
is omitted then all counters are displayed.
,
/CONFIGURATION
/STATE
SHOW FACILITY
is the name
Counter-name
and
.
/LINK
node-list
. If
file-spec
RTR Command Line Interface 6–137
. If
Advertisement
Table of Contents
