Table of Contents
Advertisement
RTR Utility Error Messages
%RTR-F-SPUJOUFIL, Spurious RTR journal file found - remove extra file, or
CREATE JOURNAL /SUPERSEDE and submit SPR
Explanation: A spurious RTR journal file has been found which does not
correspond to the other journal files on the system. This status may be
returned by the CREATE FACILITY and SHOW JOURNAL commands.
Probable cause:
System management error. A user has copied a journal file, or a disk
containing a journal file. RTR can now see extra journal files, or copies, that
do not belong in the set.
Corrective action, either:
(a) Check the log for the relevant filenames, and delete or move the spurious
journal file or files, or
(b) Reissue the CREATE JOURNAL /SUPERSEDE command (in this case
any recovery information in the old journal is lost).
%RTR-I-STACOMSRV, Starting command server on node [A][A]
Explanation: Indicates that a command server is being started on node [A].
%RTR-E-SUPCHAEND, Superfluous characters at end of expression, [A]
Explanation: The expression is invalid because the characters [A] at the end
of the expression could not be interpreted.
%RTR-I-SYSSRVCOM, [A] completed on channel [A]
Explanation: Displays the name [A] of the operation that completed on a
channel after issuing a "SYS$SYNCH" command.
%RTR-I-SYSSRVNOW, [A] posted with no wait on channel [A]
Explanation: Displays the name [A] of the operation that was issued with
the "/NOWAIT" qualifier on channel [B].
%RTR-E-TEMPLATE_NOT_FE, Template link [A] valid for front-ends only
Explanation: Template link names are valid for front end roles only. It is
an error to attempt to associate a template link name with the router or
back end roles. A template link is link whose name contains one or more
wild characters chosen from the set "*?%". '*' indicates a sequence of wild
characters; '?' and '%' indicate an occurrence of a single wild character.
%RTR-F-TIOSYS_FAILURE, General failure in TIO
Explanation: General failure in terminal I/O.
%RTR-F-TIO_BADROWCOL, The terminal is defined as : rows = [A] and cols =
[A]
Explanation: Cannot use the terminal; rows or columns is set to 0. For
UNIX platforms, please use "stty -a" to check rows and columns. Then use a
command like "stty rows 50 cols 132" to set them correctly.
%RTR-E-TOOBIG, [A] may not be greater than [A]
Explanation: The value of qualifier [A] must be less or equal to [B].
%RTR-F-TOOMANCHA, Too many channels already opened
Explanation: Too many channels already opened.
D–24 RTR Utility Error Messages
Advertisement
Table of Contents
