Compaq AA-Q88CE-TE System Manager's Manual page 202

SET TRANSACTION
Usage Notes
The command can only be executed on a backend node in which the journal is
located and the RTR log file must be turned on to record the transaction changes.
RTR needs to be started before using this command.
When a transaction's state is changed, the new state is written to the RTR journal
synchronously. RTR will try to determine whether the change also affects other
portion of RTR environment. For example, in a runtime situation where RTR
routers and RTR backend servers are active, the RTRACP will send the new
status to applicaiton servers as well as RTR routers to make sure that the change
takes effect on all nodes in the RTR facility or facilities.
However, in an off-line situation where an RTR facility has not been created, RTR
will simply update the transaction state in place in the RTR journal. The RTR
log file must be turned on before using the
the state changes. See the
There are eight legitimate situations where you can change a transaction's state;
See Table 6–19.
Parameters
transaction-id
Specifies a particular transaction or transactions whose transaction state you
want to change. The
DUMP JOURNAL
If no transaction_id
specifying qualifiers are processed by the command.
Qualifiers
/BEFORE[=date]
Selects only those transactions whose timestamp is before the specified date.
Default is the current date.
/STATE=current_state
Selects a particular transaction or a set of transactions that are in the specified
transaction state. This qualifier is required and the
state
specified.
Value of
SENDING
VOTED
COMMIT
EXCEPTION
PRI_DONE
Use the
current state of a particular transaction.
/FACILITY
/FACILITY=RTR$DEFAULT_FACILITY (D)
Specifies the name of a facility for selecting transactions. The default facility,
RTR$DEFAULT_FACILITY, is used if this qualifier is not specified.
6–126 RTR Command Line Interface
SET LOG
transaction_id
and
SHOW TRANSACTION
is specified then all transactions ("*") that satisfy the
may be one of the following:
state
DUMP JOURNAL or SHOW TRANSACTION
SET TRANSACTION
command.
format is the same as that displayed by
commands.
command to help you find what is the
command to record
value must be
state