Compaq AA-Q88CE-TE System Manager's Manual page 144

DISPLAY BAR
Qualifiers
/AVERAGE=(keyword,...)
/NOAVERAGE
Specifies that the items being monitored relating to
average. This allows a number of items to be averaged in one qualifier.
The
keyword
Keyword
NODE
LINK
FACILITY
PROCESS
PARTITION
FE_TRANSACTION
TR_TRANSACTION
BE_TRANSACTION
/BELL[=Boolean-expression]
/NOBELL (D)
Sends a bell character to the terminal if
(non-zero).
/BLINK[=Boolean-expression]
/NOBLINK (D)
Specifies that the displayed value blinks if
(non-zero).
/BLANK[=Boolean-expression]
/NOBLANK (D)
Specifies that the displayed value is replaced by blanks if
evaluates to True (non-zero).
/BOLD[=Boolean-expression]
/NOBOLD (D)
Specifies that the item is displayed in high intensity if
evaluates to True (non-zero).
/CHARACTER[=char]
/NOCHARACTER
/CHARACTER="a" (D)
Specifies the character used to draw bar charts. The line drawing character set
is used to display them. By default, the character ''a'' is used, which corresponds
to a rectangular block in the character set. If /NOCHARACTER is given then
no characters are displayed and the bar is visible only if attributes have been
specified. This can be used to draw a scale behind the bar chart.
/DAMPING[=damping-factor]
/NODAMPING (D)
Specifies that the value displayed is to fluctuate more slowly than the raw
measured value. The default for
relevant if
6–68 RTR Command Line Interface
can be one of the following:
Meaning
Node data items
Link data items
Facility data items
Process data items
Partition data items
Frontend transaction data items
Backend transaction data items
Router transaction data items
damping-factor
/VALUE=CURRENT .
keyword are displayed as an
evaluates to True
Boolean-expression
Boolean-expression
Boolean-expression
Boolean-expression
is one. Damping is only
evaluates to True