Compaq AA-Q88CE-TE System Manager's Manual page 177

MONITOR
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/COUNT=nr-updates
/COUNT=infinite (D)
Specifies how many times the RTR utility updates the screen before exiting or
returning to the prompt.
RTR>
The default is that RTR updates the screen until CTRL-Z, CTRL-Y or another
RTR command is entered. The qualifier may be used when the
/COUNT /OUTPUT
qualifier is being used to redirect output to a file. In this case,
nr-updates
specifies how many screen images are written to the file.
/FACILITY=facility-name
/NOFACILITY (D)
Specifies the name of the facility to be monitored. This is only meaningful if at
least one facility counter is displayed.
/IDENTIFICATION=process-id
/NOIDENTIFICATION (D)
Specifies the hexadecimal process-id of the process to be monitored. This is only
meaningful if at least one process counter is to be displayed.
/INTERVAL[=delay-seconds]
/INTERVAL=2 (D)
Specifies how frequently RTR updates the screen. is the number
Delay-seconds
of seconds that RTR waits after completing one screen update before starting the
next. Note that the interval between updates will always be slightly longer than
Delay-seconds , depending on the complexity of the display and the number of
nodes being monitored.
/LINK=link-name
/NOLINK (D)
Specifies the node name for the link to be monitored. This is only meaningful if
at least one link counter is to be displayed.
/NODE=node-list
/NODE=default-node-list (D)
Specifies the names of the nodes to be monitored. If is omitted then
node-list
the local node is monitored.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file . If
file-spec
/OUTPUT or file-spec is omitted then the standard or default output is used.
/PARTITION=partition-name
/NOPARTITION (D)
Specifies the names of the partitions to be monitored. Partitions names have the
form .
node$facility$partition-id
/RESUME
/NORESUME (D)
Re-executes the last MONITOR command. The qualifiers /OUTPUT, /INTERVAL
and /COUNT may be used with /RESUME. All other qualifiers are ignored. This
RTR Command Line Interface 6–101