Table of Contents
Advertisement
Specifies the length of the key field in enqueued messages in
length_of_key=nnnn
bytes. Use this qualifier only if the key field type is string, since the key length is
in other cases implied by the key type. The default value for
bytes.
offset_of_key=nnnn
Specifies the offset of the key within the messages in bytes.
The default is zero, that is, the key is at the start of the messages.
Specifies the lower bound of the key range that servers in the
low_bound=
partition will service. The interpretation of
the key is of type string then it is interpreted as text, otherwise it is interpreted
as a numeric value. The default for
can fit in the specified key type.
If the key bound value length is less than the key length (given in
), the key bound will automatically be null-padded to the required
length_of_key
length.
high_bound=
Specifies the upper bound of the key range that servers in the
partition will service. The interpretation of
If the key is of type string then it is interpreted as text, otherwise it is interpreted
as a numeric value. The default for
can fit in the specified key type.
If the key bound value length is less than the key length (given in
), the key bound will automatically be null-padded to the required
length_of_key
length.
The
/KEYn=keysegdesc
qualifier.
/xxx_OF_FIELD
/LENGTH_OF_FIELD=key-field-length
/LENGTH_OF_FIELD=4 (D)
Specifies the length of the key field in the enqueued messages in bytes. Use this
qualifier only if the key field type is string, since the key length is in all other
cases implied by the key type. The default value for
/LOW_BOUND=low-bound
/LOW_BOUND=min-val-for-key-type (D)
Specifies the lower bound of the key range that the server handles. The
interpretation of
low-bound
string then it is interpreted as text, otherwise it is interpreted as a numeric
value. The default for
low-bound
specified key type.
If the key bound value length is less than the key length (given in /LENGTH_OF_
FIELD), the key bound will automatically be null-padded to the required length.
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in
node-list
is omitted then the command is executed only on the node where the
command was issued.
CALL RTR_OPEN_CHANNEL
low-bound
is the smallest possible value that
low-bound
high-bound
is the largest possible value that
high-bound
Note
qualifier is an alternative to use of the
depends on the key type. If the key is of type
is the smallest possible value that can fit in the
RTR Command Line Interface 6–19
is four
key-length
depends on the key type; if
depends on the key type.
is four bytes.
key-length
. If
node-list
Advertisement
Table of Contents
