Show Rtr - Compaq AA-Q88CE-TE System Manager's Manual

SHOW RTR

Display the configuration and status of RTR.
Format
SHOW RTR
Command Qualifiers
/CLUSTER
/COUNTER[=counter-name]
/FULL
/NODE[=node-list]
/OUTPUT[=file-spec]
/STATUS
/VERSION
Description
The
SHOW RTR
Qualifiers
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither
nodes specified by the latest
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/COUNTER[=counter-name]
/NOCOUNTER (D)
Specifies that the per node counters are also to be displayed.
name of the counter to be displayed. If
will be displayed.
/FULL
/NOFULL (D)
Equivalent to specifying
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in
node-list
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file
/OUTPUT
command displays the configuration and status of RTR.
nor is specified then the command is executed on the
/NODE /CLUSTER
SET ENVIRONMENT
Counter-name
/COUNTER/STATUS
is omitted then the command is executed only on the node where the
or is omitted then the standard or default output is used.
file-spec
Defaults
/NOCLUSTER
/NOCOUNTER
/NOFULL
/NODE=default-node-list
/OUTPUT=stdout
/NOSTATUS
/NOVERSION
command. If no
is omitted then all counters
counter-name
may contain wild card characters.
.
RTR Command Line Interface 6–161
SHOW RTR
SET ENVIRONMENT
Counter-name is the
node-list . If
file-spec . If