4.3 VGA Win 95 Driver Support
These drivers are designed to work with Microsoft Windows 95. You
may install these drivers through Windows 95.
4.4 Ethernet Software Configuration
The PCA-6145B's on-board Ethernet interface supports all major net-
work operating systems. I/O addresses and interrupts are easily config-
ured via the DIAG 9008.EXE program. To execute the configuration, to
view the current configuration, or to run diagnostics, do the following:
1. Power the PCA-6145B on. Ensure that the DIAG 9008.EXE file is
located in the working drive.
2. At the prompt type DIAG 9008.EXE and press <Enter>. The Ethernet
configuration program will then be displayed.
3. This simple screen shows all the available options for the Ethernet
interface. Just highlight the option you wish to change by using the Up
and Down keys. To change a selected item, press <Enter>, and a
screen will appear with the available options. Highlight your option
and press <Enter>. Each highlighted option has a helpful message
guide displayed at the bottom of the screen for additional information.
4. After you have made your selections and are certain it is the configu-
ration that you want, press ESC. A prompt will appear asking if you
want to save the configuration. Press Y if you want to save.
The Ethernet Setup Menu also offers three very useful diagnostic func-
tions. These are:
1. Run EEPROM test
2. Run Diagnostics on Board
3. Run Diagnostics on Network
Each option has its own display screen which shows the format and result
of any diagnostic tests undertaken.
Note:
Ethernet cannot use IRQ12. Because IRQ12 is
assigned to PS/2 Mouse.
39
Chapter 4