2. At the prompt, type AWDFLASH.EXE and press <Enter>. The VGA
configuration program will then display the following:
3. At the prompt, type in the BIN file which supports your display. When
you are sure that you have entered the file name correctly press
<Enter>. The screen will ask "Do you want to save?" If you wish to
continue press Y. If you change your mind or have made a mistake
press N to abort and end the setup procedure.
4. If you decide to continue, the program will create a BIOS.OLD file
which contains the existing BIOS configuration. The prompt will then
ask "Are you sure you want to save new configuration?" Press Y if
you want the new file to be written into the BIOS. Press N to exit the
program.
The new VGA configuration will then write to the ROM BIOS chip. This
configuration will remain the same until you run the AWDFLASH.EXE
program and change the settings.
PCA-6145 User's Manual
Figure 4.1: VGA Setup screen
38