Setting The Voltage Selector Switch - Epson ActionPC 5000 User Manual

Setting the Voltage Selector Switch

Your system is powered by a 200 watt power supply. The
power supply voltage is controlled by a switch on the
computer's back panel that may be set to 110 VAC or 220 VAC.
The computer is shipped with the voltage selector switch set to
110 VAC. This setting is appropriate for line source voltages
between 100 and 120 VAC. This is generally the appropriate
setting if you will use the computer in North America, South
America, or Japan.
If you plan to operate the computer in the United Kingdom,
Europe, or some South American countries, you will almost
certainly need to reset the voltage selector switch to 220 VAC.
Line source voltages between 200 and 240 VAC are acceptable
with the switch set to 220 VAC.
Caution
before you turn on the power to your system you must be
sure the voltage selector is set to the appropriate setting for
the electrical power source in your location or you will
seriously damage your system.
To change the voltage selector switch setting, slide the switch
to the left to select 110 VAC, or to the right to select 220 VAC.
voltage selector switch
Setting Up Your System 1-3