Advertisement
3
Removing the Exhaust System
No Parts Required
Removing the Muffler and Heat Shield
Note: Exhaust system weight: approximately 39.5 kg (88
lb).
1. Support the exhaust system with lifting equipment
(Figure
7).
2. Remove the band clamp and the lower guillotine clamp
that secures the muffler to the turbocharger-exhaust
pipe
(Figure
8).
Note: Retain the clamps for installation in
the Bellows-Alignment Jig (page 5)
Guillotine Clamp and the Band Clamp (page
Figure 7
Installing
and
Installing the
8).
1. Flange nut
2. Guillotine clamp
3. Band clamp
3. Remove the 4 flange locknuts (8 mm), 4 bolts (8 x
120 mm), and rear mounting plate that secure the
exhaust-system mount to the front right ROPS tube
(Figure
9).
Note: Retain the locknuts, bolts, and mounting plate
for installation in
Turbocharger Outlet Pipe (page
1. Bolts (8 x 120 mm)
2. Rear mounting plate
3. ROPS tube
4. Separate the muffler from the turbocharger-exhaust
pipe and remove the muffler from the machine
10).
Note: Do not remove the heatshield from the muffler.
4
Figure 8
4. Turbocharger-exhaust
pipe
5. Muffler inlet pipe
Assembling the Muffler to the
7).
Figure 9
4. Exhaust-system mount
5. Flange locknuts (8 mm)
(Figure
Advertisement
