Seat Tarraco 2022 Owner's Manual page 87

Changing the battery
●
Unfold the vehicle key shaft.
●
Remove the cover from the back of the vehi-
cle key in the direction of the arrow
›››
.
●
Remove the battery from the compartment
›››
with a suitable fine object Fig. 66.
●
Fit a new button battery into the compart-
›››
ment .
●
Press the cover onto the key housing until it
clicks into place.
WARNING
Swallowing a battery with a 20 mm diameter
or any other button battery can cause seri-
ous and even fatal injuries within a very short
time.
●
Keep the vehicle key and key fobs with bat-
teries out of reach of children.
●
If you suspect that someone may have
swallowed a battery, seek immediate medi-
cal attention.
Keyless Access system Opening and closing
NOTICE
●
If the battery is not changed correctly, the
vehicle key may be damaged.
›››
Fig. 65 ,
●
Use of unsuitable batteries may damage
the vehicle key. For this reason, always re-
place the dead battery with another of the
same voltage, size and specifications.
●
When fitting the battery, check that the po-
larity is correct.
For the sake of the environment
Please dispose of your used batteries cor-
rectly and with respect for the environment.
Synchronize the vehicle key
If the button is pressed frequently outside of
the vehicle range, it is possible that the vehicle
can no longer be locked or unlocked using the
key. In this case, the key must be resynchron-
ised as described below:
●
Unfold the vehicle key blade
●
If necessary, remove the cover from the driver
›››
door handle page 93.
●
Press the button on the vehicle key. For this,
it must remain with the vehicle.
●
Open the vehicle within one minute using the
key blade. The key has been synchronised.
●
If necessary, fit the cap.
Keyless Access system
Locking and unlocking with the Key-
less Access system
Fig. 67 Keyless Access: proximity zones.
›››
page 83 .
Fig. 68 Driver door lever: sensor surfaces.
›››
Fig. 68
Unlocking sensor surface on the inside of
A
the door handle.
85