Seat Tarraco 2022 Owner's Manual page 195

Pay special attention when using ACC in the
following situations:
On curves
The ACC may not detect the vehicle in front
on a curve, or may regulate the distance from
›››
vehicles in other lanes Fig. 142
Vehicles outside the sensor zone
In the following situations the ACC may not re-
act, or may react slowly or inappropriately:
●
Vehicles that are not aligned while driving or
that are outside the sensor's detection area,
›››
such as motorcycles Fig. 142
●
Vehicles that move into your lane, a short dis-
›››
tance from your vehicle Fig. 143
●
Vehicles with loads or accessories that pro-
trude from the sides, rear or roof.
Objects that are not detected
The ACC function only detects and reacts to
vehicles moving in the same direction. There-
fore it does not detect:
●
People
●
Animals
●
Vehicles travelling in the opposite direction or
crossing the road.
●
Other stationary obstacles
ACC - Adaptive Cruise Control Assistant systems
The ACC does not react to stationary vehicles.
If, for example, a vehicle detected by the ACC
turns or moves over and there is a stationary
vehicle in front of it, the ACC will not react to
the second vehicle
WARNING
.
Using the ACC in the above situations can
cause serious accidents and injuries, and
you could break the law.
Troubleshooting
ACC not available
.
.
The indicator lamp lights up yellow:
●
The radar sensor is dirty or adjusted in-
correctly. Take into account the warnings
described at the beginning of this chapter
›››
page 182
●
There is a fault or a defect. Turn off the vehi-
cle's ignition and turn it on again after a few
minutes.
●
If the problem persists, consult a specialised
workshop.
The ACC does not work as expected
●
radar sensor to operate properly
●
›››
Fig. 143 .
tomatically. Wait for them to cool down and
check the operation again.
●
ing are normal and do not indicate any anoma-
lies.
The following conditions may lead the ACC
not to react:
●
●
●
●
●
●
●
●
●
●
Make sure that the conditions are met for the
›››
If the brakes overheat, regulation stops au-
Unusual noises during automatic ACC brak-
The accelerator or brake is depressed.
No gear is engaged or the vehicle is in gear R.
The vehicle is reversing.
ESC is operating.
The driver is not wearing his/her seat belt.
The RPM is too high or too low.
A vehicle brake light is faulty.
A trailer brake light is faulty.
The parking brake is applied.
Driving on an excessive slope.
page 182.
193