Seat Tarraco 2022 Owner's Manual page 126

Turning on the "Leaving home" light
●
Switch the ignition off.
The "Leaving Home" light turns on if the light
control is in position and the light sensor
detects darkness.
The lights-off delay countdown starts when the
last door or rear lid of the vehicle is closed.
Turning off the "Leaving home" light
●
It switches off automatically after the set
lights-off delay time has elapsed.
●
EITHER: it is automatically deactivated if, 30
seconds after the function has been activated,
any vehicle door or the rear lid is still open.
●
OR: rotate the light switch to position .
●
OR: switch on the ignition.
Welcome light
The welcome light is a light located on the exte-
rior mirrors facing the ground which is switched
on or off if the lights control is in the
tion and the "Coming Home" or "Leaving Home"
function is switched on or off.
"Coming home" and "Leaving home" set-
tings
The duration of the lights-off delay can be set
in the vehicle settings menu of the infotainment
system, where the function can also be activa-
›››
ted and deactivated page 37.
124
Lights
Dynamic headlight range control
The headlight range is automatically adjusted
according to the vehicle load status when they
are switched on.
WARNING
If the dynamic headlight range control fails
or does not work properly, the headlights
could dazzle and distract other road users.
This could cause accidents and lead to seri-
ous injuries.
●
Immediately go to a specialist workshop
and have the headlight range control system
checked.
Driving abroad
The light beam of the dipped beam lights is
asymmetric: the side of the road on which you
are driving is lit more intensely.
When a car that is manufactured in a country
posi-
that drives on the right travels to a country that
drives on the left (or vice versa), it is normally
necessary to cover part of the headlight bulbs
with stickers or to change the adjustment of the
headlights to avoid dazzling other drivers.
In such cases, the regulations specify certain
light values that must be complied with for des-
ignated points of the light distribution. This is
known as "Tourist light".
The light distribution of the headlights allows
the specific "tourist light" values to be met
without the need for stickers or changes being
made to the settings.
Note
"Tourist light" is only allowed temporarily. If
you are planning a long stay in a country that
drives on the other side, you should take the
vehicle to an Authorised Technical Service to
change the headlights.
Interior lights
Lighting of the instrument cluster,
displays and controls
The brightness of the instrument and control
lighting can be adjusted in the infotainment
system:
●
Select
> Settings > Lighting >
Vehicle interior lighting; OR
Interior settings > Lighting > In-
strument cluster.
The set intensity automatically adapts to
changes in ambient brightness in the vehicle.
When the automatic dipped beam light
is turned on, a sensor automatically turns the
dipped beam light on or off, as well as the in-
strument and control lighting, depending on the
ambient brightness.
>