Seat Tarraco 2022 Owner's Manual page 125

●
OR: if the main beam assistant is on, but the
main beam does not turn on, press the turn
signal and main beam lever forwards to turn
the main beam on manually. Pull the turn signal
and main beam lever back to switch off the
main beam manually, if necessary.
●
OR: switch off the ignition.
System limitations
In the following cases, the main beam headlight
must be switched off manually because the
main beam assist will not disconnect it on time
or disconnect it at all:
●
On roads with insufficient lighting with very
reflective signs
●
If road users are insufficiently lit up, e.g. pe-
destrians or cyclists.
●
On closed curves, when the traffic in the
opposite direction is partially hidden, on pro-
nounced slopes or inclinations.
●
On roads with traffic in the opposite direction
and with a central reservation barrier where the
driver can see over it e.g. lorry drivers.
●
In the event of fog, snow or heavy rain
●
In the event of dust or sand storms
●
If the windscreen is damaged in the camera's
field of vision.
●
If the camera's field of vision is misted up, dirty
or covered by a sticker, snow or ice.
●
If the camera is damaged or if the power sup-
ply has been cut off.
Vehicle lighting Lights
WARNING
The convenience features of the main beam
assist should not encourage the taking of
risks. The system is not a replacement for
driver concentration.
●
You are always in control of the main beam
and adapting it to the light, visibility and
traffic conditions.
●
It is possible that the main beam headlight
control does not recognise all driving situa-
tions and is limited under certain circumstan-
ces.
●
When the field of vision of the camera is
dirty, covered or damaged, operation of the
main beam control may be affected. This
also applies when changes are made to the
vehicle lighting system, for example, if addi-
tional headlights are installed.
NOTICE
To avoid affecting the operation of the sys-
tem, take the following points into considera-
tion:
●
Clean the field of vision of the camera reg-
ularly and make sure it is free of snow and
ice.
●
Do not cover the field of vision of the cam-
era.
●
Check that the windscreen is not damaged
in the area of the field of vision of the cam-
era.
Note
● The headlight flasher can be turned on and
off manually at any time with the turn signal
›››
page 121
and main beam lever
● If there are objects that radiate light in the
camera's area of influence, e.g. a portable
navigation system, this may affect the oper-
ation of the main beam assist system.
"Coming home" and "Leaving home"
function (exterior orientation light-
ing)
The "Coming home" and "Leaving home" func-
tion lights up the vehicle's immediate surround-
ings when getting into and out of it in the dark.
This light is automatically controlled by a light
sensor.
Turning on the "Coming home" light
●
Unlocks the vehicle (if the light switch is in
position and the light sensor detects dark-
ness).
Turning off the "Coming home" light
●
It turns off automatically once the lights off
delay time has elapsed.
●
OR: lock the vehicle.
●
OR: rotate the light switch to position .
●
OR: switch on the ignition.
.
123