Seat Tarraco 2022 Owner's Manual page 124

Parking light on both sides
●
Switch the ignition off.
●
Place the light switch in position
●
Lock the vehicle from the outside.
In doing so, only the side lights of both head-
lights light up, and additionally the tail lights will
do so partially.
WARNING
Improper or lack of use of the turn signals,
or forgetting to deactivate them can confuse
other road users. This could result in a seri-
ous accident.
●
Always give warning when you are going to
change lane, overtake or when turning, acti-
vating the turn signal in good time.
●
As soon as you have finished changing
lane, overtaking or turning, switch the turn
signal off.
WARNING
Incorrect use of the headlights may cause
accidents and serious injury, as the main
beam may distract or dazzle other drivers.
122
Note
● When you turn the ignition off without hav-
.
ing turned the turn signals off, an acoustic
signal sounds while the driver door is open.
This is intended as a reminder to switch off
the turn signal, unless you wish to leave the
parking light on.
● If the convenience turn signals are oper-
ating (three flashes) and the other conven-
ience turn signals are switched on, the active
part stops flashing and only flashes once in
the new part selected.
● The turn signal only works when the igni-
tion is switched on. The hazard warning lights
also work when the ignition is switched off.
● The main beam headlights can only be
switched on if the dipped beam headlights
are already on.
● If a trailer turn signal malfunctions, the
control lamp will stop flashing (trailer turn
signals) and the vehicle turn signal will flash
at double speed.
● In cold or damp weather conditions, the
headlights, tail lights and turn signals may
mist up inside temporarily. This is normal and
in no way effects the useful life of the vehicle
lighting system.
● The parking light does not activate auto-
matically if the left- or right-hand turn signal
is left on and the ignition is disconnected.
Lights
The main beam assist automatically prevents
glare from vehicles moving in the opposite di-
rection or ahead in the same direction. In addi-
tion, the main beam assist detects illuminated
areas and disconnects the main beam head-
light when passing, e.g. by populated areas.
Within its limitations, the assist system automat-
ically connects or disconnects the main beam
headlight depending on the environmental and
traffic conditions, as well as the speed
●
position
●
nal and main beam headlights lever forwards
›››
When the main beam assist is switched on,
the control lamp
screen turns on. When the main beam is on, the
blue main beam control lamp
ment cluster switches on.
Switching the main beam assist off
●
than
●
signal light and main beam headlights lever
back
Main beam assist (Light Assist)
Switching on the main beam assist
Turn on the ignition and turn the light switch to
.
From the base position, press the turn sig-
Fig. 105 .
3
on the instrument cluster
on the instru-
Turn the headlight switch to a position other
.
EITHER: if main beam assist is on, pull the turn
›››
Fig. 105 .
4
›››
.