Seat Tarraco 2022 Owner's Manual page 117

Removing the headrests from the second
row of seats
●
If necessary, adjust the backrest of the seat
so the head restraint can be removed.
●
Push the head restraint up as far as it will go
›››
in Introduction on page 113.
●
Remove the head restraint completely while
›››
pressing button Fig. 97 .
1
Installing the headrests of the second row of
seats
●
Unlock the rear seat backrest and fold it for-
›››
ward slightly page 111.
●
Place the head restraint in the correct posi-
tion on the guides of the corresponding back-
rest and insert it.
●
Lower the head restraint while pressing but-
ton .
1
●
Raise the rear seat backrest and lock it.
WARNING
Remove the rear headrests only when it is
necessary to fit a child seat. After removing a
child seat, refit the headrest immediately.
Note
The headrests of the third row of seats can-
not be removed.
Seats and head restraints Seat functions
Seat functions
Memory function
Fig. 98 On the outer side of the driver seat:
memory buttons.
Memory buttons
Individual settings for the corresponding seat
can be stored with the memory buttons. Addi-
tionally, settings for the exterior mirrors can be
saved with the memory buttons of the driver
seat.
The settings will also be saved in the key or in
the user of the online services, depending on
the version.
Save the settings of the driver seat and the
exterior mirrors while driving forward
●
Apply the electronic parking brake.
●
Move the gearshift to the neutral position.
●
Switch the ignition on.
●
Adjust the driver seat and the exterior mirrors.
●
Press for longer than 1 second
●
Press the memory button in which to store the
settings within approx. 10 seconds. A warning
sound will confirm they have been stored.
Storing the passenger rear view mirror set-
tings while driving in reverse
●
Apply the electronic parking brake.
●
Move the gearshift to the neutral position.
●
Switch the ignition on.
●
Press the required memory button.
●
Select reverse gear.
●
Adjust the front passenger exterior mirror so
that you can see, for example, the kerb edge
well.
●
The new position of the mirror will be stored
automatically and allocated to the vehicle key
that was used to unlock the vehicle.
Activating settings
●
With the vehicle stopped and the ignition
switched on, press and hold the correspond-
ing memory button until the saved position is
reached.
●
OR: With the ignition switched off and the
driver's door open, briefly press the corre-
sponding button.
The front passenger side exterior mirror auto-
matically changes from the position stored for
reversing as soon as the vehicle moves forward
›››
Fig. 98.
115