Using the net partition
Fig. 203
Net partition fitted.
The purpose of the net partition is to prevent
the items in the boot from moving into the cabin,
e.g. in the event of sudden braking.
Fitting the net partition
The partition net can be fitted behind the rear
seat or, depending on the features, behind the
front seats with the second row of seats low-
ered.
●
If required, remove the rear shelf
›››
page 289.
●
Folding out the net partition.
●
Hook the net partition to the left-hand side
›››
roof housing
Fig. 203
Be sure to pull the cross rod down past the up-
per position.
294
●
Hook in the net partition on the rear right-
hand side roof housing by pressing on the bar
›››
Fig. 203
●
Secure two hooks of the partition net to the
fastening rings of the boot
tighten the straps firmly.
Removing the net partition
●
If required, remove the rear shelf.
●
Loosen the straps from the net partition.
●
Release the net hooks from the fastening
›››
rings
●
Unhook the net partition on the right-hand
side roof support
on the cross rod.
●
Unhook the net partition from the left-hand
side roof housing.
●
Fold in the net partition.
●
If required, fit the rear shelf.
WARNING
In order to ensure the proper functioning of
the luggage restraint systems (backrests to-
gether with the net partition), place the sec-
ond row of seats in their rearmost position to
avoid the possibility of the load on top mov-
ing forward. Risk to vehicle occupants.
.
A
Storing objects
.
A
›››
Fig. 203
B
Fig. 203
.
B
›››
Fig. 203
by pressing
A
WARNING
During a sudden driving or braking manoeu-
vre, or in the event of an accident, objects
could be flung though the interior and cause
and
serious or fatal injuries.
●
Check whether the cross rods are cor-
rectly engaged.
●
Always secure objects, even when the net
partition is properly assembled.
●
There should be nobody behind the net
partition when the vehicle is moving.
NOTICE
If the net partition is secured incorrectly or
to incorrect points, this may damage the ve-
hicle.